Hi,
I am new to this forum.
I have searched the posts and did not see a thread that looked like it would answer my question(s).
I do not understand the instructions in the user guide about interpreting the results at the end of a session.
Say I manually set the sensitivity at the beginning of a session to 8 (page 6 in the user guide -only the top LED is on/green).
When I am done with a session, I press the start/stop button.
Say the LED's flash at what appears to be "Level" 6 (3 green and 5 yellow on page 12 of the user guide).
Alternately, the display flashes a single LED green, being the fifth LED up from the bottom.
So how do I interpret those indicators per the chart on page 13 of the user guide?
According to the user guide on page 6 (as I understand it), the single green flashing LED is the lowest sensitivity level I have reached.
So should I be looking at the "5" column on the chart on page 13 because the lowest green flashing LED is the fifth one from the bottom?
Or should I be looking at the "8" column because that is what I had manually set the sensitivity level to when I began the session?
Hope my questions are understandable.
I think the user guide's explanations aren't very clear.
Thanks, Bob
Bookmarks