Adjust Old Style Proteus Lightframe LED's

[jturner]

Recently I purchased an older Proteus with 2.0 Os. The LED's on the right side of the light frames are significantly brighter than the one's on the left, most noticeable on the green one's.

I updated to 3.2 Os. No difference. Is there any way to balance the strength of the left and right signal for the proteus for these exposed LED glasses using the Proteus editor settings.

Thanks.

Jim

[Andy]

You have a bad set of Ganzframes. Do you have another set you can try?
There is no separate signal to the left and right of bi-colour Ganzframes. The wiring is Green on one channel, Red on the other. Left and Right are paralleled to each other.

[jturner]

Thank you, Andy. I checked the Proteus with another set of lightframes and it produced the same result. When the light level is adjusted toward a "0" level, when one set of LED's are off (left), the other set is still slightly on (right). During a session, the higher brightness is quite noticeable.

Any suggestions?

- Jim

[Andy]

Sounds like you have a broken Proteus. Can you return it to the seller for a refund?
If not, send me an e-mail and we can get it repaired for you.