Hello. I managed to run Procyon Editor under Linux with wine. It also communicates with the device via USB using the cp2101 kernel driver. Here is small howto:
- create new directory and put there cp2101.c from the linux kernel source (/drivers/usb/serial/cp2101.c)
- modify the file by adding the line
{ USB_DEVICE(0x10c4, 0x82f9) },
right after the line
static struct usb_device_id id_table [] = {
- create the Makefile according to http://www.cyberciti.biz/tips/compil...el-module.html and compile the driver
- load the driver (insmod cp2101.ko)
- a /dev/ttyUSB0 file should be created - you can check the details with the dmesg command. Check also the file permissions so you can read and write it.
- install the Procyon Editor using wine
- create the symbolic link ~/.wine/dosdevices/com5 pointing to /dev/ttyUSB0
- run the installed Procyon Editor and configure it to use the COM5 serial port
- enjoy
Bookmarks