Procyon Ganzframe Adapters

[gordon]

I suspect the answer is "no" but one feature I liked from the Proteus was the ability to run 2 sets of light frames at once. Any way to split the signal - or would power be too low? I'm VERY interested in running the same session with a partner, but I'm a Procyon owner and not looking to buy another machine.

[Andy]

Hi and welcome back. Make sure you "subscribe" to any threads of interest and you will receive an e-mail letting you know when there's a new reply.

I also added an RSS feed today for the forum so if that's your thing, add this link to your homepage or RSS reader:

http://www.mindplacesupport.com/foru...&newposts=true

Most browsers have an "add RSS" button if they detect the RSS feed from the forum.

-Andy.

[Andy]

Using the adapter with a headphone splitter would get you two 2-colour frames running off one Procyon, but nobody's made a splitter for Procyon 3-colour lightframes, and I'm not about to!

-Andy.

[synaesthesia]

Thanks Andy , I'll enquire about the raw cable as I'm ok with a soldering iron if my back is against the wall

Can you tell me the assignments of tip and ring regards red/green wires for the 3.5mm stereo female end I have to add? ( I want to adapt older style Red / Green glasses for Audiostrobe use with my Procyon).

Mark

[Andy]

Hi Mark;

The pictures above show the wiring of the Procyon cable.

On Red/Green Lightframes, Tip is the Red LEDs, Ring is the Green LEDs.

Good luck!

-Andy.

[Andy]

FYI - Adapters should be available again. A bunch more got built.

The new ones are a little shorter - they're about 6" long. No need for all that extra cable!

[Reality Engineer]

Hey Andy,
Are you still selling these adapters?
I have a pair of Common Ground Photosonix TruBlu Light Frames I wish to use.

Thanks in Advance.

[Andy]

Hey Andy,
Are you still selling these adapters?
I have a pair of Common Ground Photosonix TruBlu Light Frames I wish to use.

Thanks in Advance.

Unfortunately, no. They were for the Rev 1&2 Procyons with the rectangular Ganzframe plugs which have been out of production for almost 10 years.

[ME111]

Are these adapters still available for Procycon rev2?