Hi there
I've had my Procyon for a couple of days, and although I've not experienced any of the amazing effects others have reported, it seems reasonably good.
I have OS 2.1.4. I have a Mac and haven't upgraded the software.
I have a question about the brightness setting. The volume and brightness controls do not respond instantly to movement and I assume they are controlled by the OS in some manner. However, on the brightness knob, if I set it to zero, and slowly increase it, there is no light and nothing happens, up until a certain point, when suddenly the LEDs come on. I personally don't like to be blinded or cause my retinas any damage, so I like to have the brightness lower (less visual effects but more relaxing (and blue light only) - and yes I do keep my eyes closed the whole time!) It thus appears there is a threshold value on the brightness knob, below which there is no light at all between there and zero. We are talking 0.5 - 1 cm of knob circumference here. Anyway, this wouldn't be so bad, but if I keep the brightness at around this threshold value, sometimes the lights cut out and I need to increase the brightness to get them to come back on. This may happen after 10 seconds or 5 minutes. I need to therefore increase them to a brightness much greater than I'd like in order for the lights to stay on the whole time. Otherwise it becomes really annoying and spoils the whole relaxation effect that the device is supposed to convey.
So any thoughts please? Do other users experience this problem? Is it a known issue with this OS version? Or is it just my device? If the latter, is it a hardware issue (likely not) or a software issue (more likely) please?
Many thanks.
Health-Spy.com
Bookmarks