Re: Wonky Ganzframes
If it is the LED strip that is uneven then that is not hard to pull up and reposition. There is very little risk of damaging the LEDs as the strips are very robust. Just be careful of the solder joints where the cable exits the frames. With careful handling this shouldn't be an issue.The glue is very sticky and should stick back and hold.
You would also have to take the diffuser off. It is just a strong double sided glue tape. Use a little screwdriver to pry it up at a point in the middle. Same with the strip. Try to only work on the side that needs adjusted.
I have disassembled and reassembled Ganzframes many times without the strength of the bond being compromised much.
3mm is not very much though and wouldn't be noticeable behind closed eyes. But I know how it is when you discover a flaw on something new (that you paid good money for too). It bugs the heck out of you for a while.
Try this first and then if needed contact Andy at the Contact Us link at the bottom and we will send you a replacement set. There is a warranty against manufacturing defects, which this falls under.
Best,
Scott
If you know something I don't, speak up! If maybe I know something you don't, ask away!
Bookmarks