Monocolor or bicolor ?

[gfredo]

Hello, i would like to know if my glasses are in multicolor or monocolor function ?

If the left decimal point is flashing : multicolor
left decimal point not flashing : monocolor, it's good ?


In the manual V3 page 11

If the left decimal point is not flashing then the Proteus is in the default ?bicolor" modality
where the red and green channels can run independently

If the left decimal point is flashing the unit is in the
?monocolor? modality,



But, it's strange because in the manual V3 page 14 :

Press SELECT and MODE simultaneously
to toggle between monochrome and
bicolor display. If the left decimal is
flashing Proteus is in bicolor mode



What is the correct settings for bicolor mode ? I'm confused
Is there a error in a manuel ?

Thanks you for your answer

[Andy]

Hello;

There was a thread about this before: http://www.mindplacesupport.com/foru...ight=monocolor

Let me know if that answers the question. You're right, though, the table on Page 14 looks to be incorrect.

-Andy.