Session 35 Bug Report

[pcreator]

Session stops and unit shuts off about 8 minutes into the session. I have version 1.7.3.

[Andy]

Thank you for reporting that. I'm going to test that now to verify.

I just tried that session, running 1.7.3 and it ran the full 15mins.

Are your batteries fresh or have you tried running this session while the Procyon is connected to your USB?
Anyone else have this issue on session #35?

[pcreator]

I replaced the batteries and still had the problem, USB was detached during session. I went back to version 1.7.2 and it ran just fine. I had that problem with session 20 on version 1.7.3 as well.

[rupert]

Hi all,

I just tested session 35 against a stopwatch on my computer. I didn't have any problems with it cutting out prematurely. Came out pretty much bang on 15minutes. Haven't tried session 20 yet... will try that tomorrow (I wanted to try it out soon anyway). One thing of note - I went directly from factory installed (1.6.8?) OS to 1.7.3. I never installed 1.7.2. Cheers

Rupert

[Christophe]

Using 1.7.3, I was able to run both 35 and 20 without a problem. I noticed however (and I don't recall having this with 1.6.8) a loud pop at the end of any session.