Unified Procyon Editor & Driver Installer for Rev1 & 2

Quote:

---

Originally Posted by Andy

It's a false reading. There's no virus or trojan in that file.

-Andy.

---

Hello, Andy

I cleaned my laptop. Deleted 'Microplugin' and then tried to install ProcyonSetup.zip, and the StopZilla Spyware program which I use on my computer showed 'MicroPlugin' and deleted it, again.

I rely StopZilla very much as it solved many of my virus problems.

Now the question is : is the ProcyonSetup.Zip supposed to have some file related to and named as 'Microplugin' ?

Would you please try at your end once again.

Thank you for your help.

Regards

Quote:

---

Originally Posted by srikrishna_ghadiyaram

Now the question is : is the ProcyonSetup.Zip supposed to have some file related to and named as 'Microplugin' ?

---

I have no idea.
I can only assure you once again that there's no virus in the file (unless it's coming from your computer). Your StopZilla program is giving you a false reading, so proceed however you wish in those circumstances.

Send the file to StopZilla if you want and have them analyze it. Not much more I can do to help you with that.

-Andy.

Quote:

---

Originally Posted by Andy

I have no idea.
I can only assure you once again that there's no virus in the file (unless it's coming from your computer). Your StopZilla program is giving you a false reading, so proceed however you wish in those circumstances.

Send the file to StopZilla if you want and have them analyze it. Not much more I can do to help you with that.

-Andy.

---

Hello, Andy

I sent a mail to StopZilla asking them to analyze the ProcyonSetup.Zip file.

When I was running scan using StopZilla, I tried again to install ProcyonSetup file, and this time, probably because StopZilla was busy doing some thing else, it did not stop installation. It completed.

Then when I tried to open the COM port, the com port com8 ( which was assigned to the SiLab bridge) was greyed out in teh Editor software. After a few attempts to disconnect the device and other MultiPort USB hub etc., at one point, Com8 became active in the Editor software. No clue why the Editor software did not recognize the Com8 port at first.

Any how, for now I am connected, and updated the OS to 2.1.6

So, now I have the basics working.

Thank you for your continued support.

Regards

Quote:

---

Originally Posted by srikrishna_ghadiyaram

Any how, for now I am connected, and updated the OS to 2.1.6

So, now I have the basics working.

Thank you for your continued support.

Regards

---

You're very welcome. Glad to hear you have it all working now! :cheers:

Enjoy!

-Andy.