This is a fairly traditional state for astral projection according to Awakening Mind I.
This book describes ways in which one would put together such a session, but talks about the benefit of having two tones playing at the same time in each ear so that you get two distinct average frequencies and two distinct offsets for the purpose of entrainment.
Leaving aside whether this is a valid approach or not, Procyon cannot handle multiple tones (voices).
So I was thinking about how one would put together a body asleep, mind awake session.
Awakening Mind I has details on how to created a body asleep, mind awake session which involve using multiple voices - I am trying to work out how to simulate this using Procyon's "limitations".
I envisage having the first segment a simple 10 minute with 3Hz offset with avg frequency around 196Hz.
The second segment in Awakening Mind I involves having two voices play in a segment of 30 minutes with 3Hz offset (avg freq 196Hz) and 10Hz offset (avg freq 400Hz). I can't do this in Procyon so I was thinking something like the following:
1: 3Hz offset with avg freq 196Hz for 5 minutes
2: 3Hz->10Hz offset with avg freq ramping from 196 to 400Hz for 2 minutes
3: 10Hz offset with avg freq 400Hz for 1 minute
4: 10Hz->3Hz offset with avg freq ramping from 400 to 196Hz for 2 minutes
Loop segments 1 to 4 three times.
I'll have to ramp the volume down/up when going from 196Hz to 400Hz as I don't think you'd want 400Hz to be too loud.
I thought using ramps might a good idea both with the offsets and frequencies rather than sharp pitch adjustment. However, it might be easier to ramp the avg frequency and just cut across to the new offset.
There is an ending segment as well, but it will probably follow a similar pattern to this really.
The question is - would this be the way to adjust a segment such as is listed in Awakening Mind I to fit with Procyon's features?
Regards
Caleb
Bookmarks