Hello,
I've searched through the past threads regarding the raw data format from the throughstream RS-232 and the USB versions. I was wondering if the USB data format is still the same as the older RS-232 setup?
ie:
9 Bytes total
Byte
1 Header
2 Header
3 Device Code Value
4 Relaxation value (255, all red; 0, all green)
5 & 6 Current 12/14 bit (rs232/usb respectively) ADC value recorded
7 Status of Thoughtstream
8 & 9 12/14 bit ADC value of the starting probe resistance set at the beginning of the session.
I don't seem to be getting a consistent 9 bytes, but rather something like 15 or 16 bytes.
This is based on the assumption that Bytes 1 and 2 are still the "header" values which have a value of "0". But to confuse the interpretation, there are a lot of file separator bytes (Decimal value "28"). Any clarification would be greatly appreciated.
Thanks,
Vinc.
Bookmarks