I am having some trouble with Procyon Editor 2.2.02 on XP and my Rev1 Procyon. I followed the guide and installed both the drivers and Procyon Editor, but when I try to run it I get the message: "When I start The drivers for the USB to serial bridge were not found. Also, the necessary installation files were not found. The USB interface with the Procyon may not work properly." Also when I try to run anything inside the editor I get another message: "The serial port is not open. Do you want to open it?" If I click on yes I just get the same question and it does this over and over again. Therefore I decided to try a couple of things such as make sure the settings are correct, install the newest drivers from TI, a complete uninstall and reinstall, etc... but whatever I did I could not get it to work. Though if I installed the old 1.7.22 version of the Procyon Editor it works just fine. Right now I have both installed and if I run version 1.7.22 it works right away, but if I try the new version it still fails. Any ideas as to what might be causing this?
Bookmarks