Results 1 to 3 of 3

Thread: Proteus Editor Install

  1. #1
    Join Date
    Apr 2006
    Location
    Calgary, Alberta, Canada
    Posts
    3,609
    Blog Entries
    3
    Rep Power
    50

    Default Proteus Editor Install

    Here is the procedure to install the Driver and Editor for your Proteus and to check that it is working:

    First, you will need to install the Proteus USB to RS-232 cable driver.
    After that is installed, you will need to install the Proteus Editor 2.5.1.

    Once they are installed, you can plug the USB cable into the computer, and into your Proteus. A small pop-up window will appear in the lower right of your desktop, showing you that the driver is being installed. If everything goes correctly, at the end of that installation you should see in that popup a reference to a COM Port number. Remember that number.

    Run the Proteus Editor, and select the menu item "Serial Port".
    Under that menu item, select "Set Comm Port".
    Choose the COM Port number from the pop-up window. If you didn't catch what that number was, you can try just selecting the highest available (non-red) port.
    Set your Proteus to "PC" mode.
    Click on the "View Realtime" button on the top of the editor. The button should change to "Port Open" and turn green.
    Click on "Run Segment" and you should see the lights on the Proteus Ganzframes start to flash (assuming the brightness is up).
    If you get to this point, then you have installed the driver and editor correctly and have established communication between you computer and the Proteus.

    From here it's important that you download and read the Proteus Session Editor Manual 2.5.1 to learn how to use the Editor.
    -Andy.

    Hey, if someone makes a good post, don't forget to click at the bottom of their post to add to their reputation!

  2. #2

    Default Re: Proteus- Astral projection

    thanks for the help. I want to say that I do not have the usb cable. Also where is the programe to install the usb cable.
    Thank you

  3. #3
    Join Date
    Apr 2006
    Location
    Calgary, Alberta, Canada
    Posts
    3,609
    Blog Entries
    3
    Rep Power
    50

    Default Re: Proteus Editor Install

    You can purchase the USB cable from MindPlace.
    The Driver for the cable is under "Proteus/TS/Procyon Driver Windows v6.7" on the Proteus support page that I linked to in the first message.
    -Andy.

    Hey, if someone makes a good post, don't forget to click at the bottom of their post to add to their reputation!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 1
    Last Post: 06-10-2012, 08:33 PM
  2. Proteus Editor
    By Erwin Loyd in forum Proteus
    Replies: 2
    Last Post: 01-24-2011, 01:09 PM
  3. Replies: 2
    Last Post: 08-02-2010, 04:39 PM
  4. Proteus Editor software
    By tucsontoad520 in forum Proteus
    Replies: 3
    Last Post: 12-05-2007, 06:44 AM
  5. Editor install problem
    By Gintaras in forum Procyon
    Replies: 1
    Last Post: 08-02-2007, 07:06 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •