Hello, I recently found my Procyon again. It shows 1.7.4 when turned on.
Trying to get caught up to the latest software.firmware etc.
I have tried follwing the vids as well as threads on installing drivers etc in win7 x64....having great difficulty. Hopefully someone could shed some light on things.
Ok, I installed the procyonsetup file with ver 1 drivers. Rebooted.
Then, I installed the silabs drivers as per the Win x64 thread. Reboot.
I then plugged in my Procyon, showed installing drivers, but then giives message of drivers not installed.
When I check device Mgr, I don't see any UART Bridge Com stuff.
I have an unrecognized driver that shows..TUSB3410 Boot Device.
This has happened the 4 times I have tried this.
Now, the USB cable I'm using is not the one that came with my Procyon(misplaced). when plugged in though, it does seem to be seeing the procyon OK, to install the drivers.
Could this be part of the problem Is the Procyon proprietary<sp>
What type of USB cable (model/type) do i need if this is the problem?
Any insight to this problem appreciated. Right now everyhting is un-installed; ready to start from scratch.
Walking away right now, till I can get some good advice from you nice folks. Thank You for your time.
Best,
David
Bookmarks