Re: Procyon editor bugs
In the editor you will notice that when a session transfer commences the Procyon switches to dL2 mode. This is triggered by code in the editor and is the necessary mode for transfer. A check is performed to be sure that the Procyon is in the proper mode before displaying the dialog. It seems there might be some cases where the mode is not switched properly. I'll investigate further. As mentioned this is an intermittent occurrence. You can in some cases restore the functioning of the Procyon by turning it off and back on. It is stuck reporting its mode status back to the software editor. This is just my initial hypothesis.
On the second case it might be that there is still data left in the temporary buffer that is used for session/segment preview. Once again just a hypothesis. Once the data is written to the Procyon all the settings are correctly recorded.
Work is ongoing with the editor so we appreciate your reports.
If you know something I don't, speak up! If maybe I know something you don't, ask away!
Bookmarks