Hi,
I was just testing some segments through the Procyon Editor (using the "Run Segments" button, and then previewing the segment through the ganzframes).
I found that at least one of the light channels is always out of sync with the other two, even if they are all on a phase setting of "0".
This is immediately visible if you set all three channels to 1hz. At least one colour will blink out of sync to the other two (and it's not always the same colour).
I was relieved to find that once the same segment is actually transferred to the Procyon as an album then it all works perfectly - all channels flash in sync.
So not a major problem, but it does make it hard to accurately preview slow, "colour wash" segments without transferring them as an album after each tweak.
Perhaps something to look at for the next software upgrade?
In other news, I am thoroughly enjoying my new Procyon - it's been a great upgrade from the Proteus .
Thanks,
Joe
Bookmarks