Interpreting LED levels/increments & sensitivity levels

Hi,
I am new to this forum.
I have searched the posts and did not see a thread that looked like it would answer my question(s).
I do not understand the instructions in the user guide about interpreting the results at the end of a session.
Say I manually set the sensitivity at the beginning of a session to 8 (page 6 in the user guide -only the top LED is on/green).
When I am done with a session, I press the start/stop button.
Say the LED's flash at what appears to be "Level" 6 (3 green and 5 yellow on page 12 of the user guide).
Alternately, the display flashes a single LED green, being the fifth LED up from the bottom.
So how do I interpret those indicators per the chart on page 13 of the user guide?
According to the user guide on page 6 (as I understand it), the single green flashing LED is the lowest sensitivity level I have reached.
So should I be looking at the "5" column on the chart on page 13 because the lowest green flashing LED is the fifth one from the bottom?
Or should I be looking at the "8" column because that is what I had manually set the sensitivity level to when I began the session?
Hope my questions are understandable.
I think the user guide's explanations aren't very clear.
Thanks, Bob

Hi Bob, and Welcome!

You should be looking at the 5 column. You are no longer at level 8. The TS has automatically adjusted the level down from 8 to 5 after you completed level 8, 7 and 6.

Thanks!
Another question...
In the progress log (given the same numbers as my previous post), what should I put in the Sens. Level and Lowest Level columns for that session?
This device really helps me clear my mind.
It's especially helpful after a stressful day.

You reached the lowest Level of 5.
Your Sensitivity Level was 6 when you stopped.

You only reached Sensitivity level 6 because you stopped before the end of the session. Completing a session (or level) will always end at level 1 (all green).

It's a bit confusing because they are both called "levels".

I would probably call the first (Sensitivity level 1-8) "Level" and the other (level 1-25) "Completion point" where 25 is the start and 1 is the finish, or something like that.