Active-X control &/or dll for Procyon (also, general AS question)?
I'm new to the Procyon, but have been very happy with the pre-programmed sessions and the Eternal Elements I & II CD's that came free with my unit. However, I have read (can't remember where) that there may be an Active-X control or dll written for the Procyon, allowing me to write my own software to control it. It's been a while since I coded (last used VB 6 - that tells you how long ago :)); but, I'm already thinking that I may wind up having the most flexibility by writing my own software vs using the editor software. Just preliminary thinking from a Procyon newbie.
Also, as a side question: I loaded the Eternal Elements I & II CD's into iTunes and synched them with my iPhone. I then set the Procyon to AS/AnL and connected the iPhone to the Aux port and played the AS sessions. All I get is the red and green lights flashing. Is that the norm since the 'music' only has 2 channels - left and right. Or, did some coded signals not pass over correctly in my iTunes > iPhone procedure :eusa_think:?
Thanks in advance for your input.
Re: Active-X control &/or dll for Procyon (also, general AS question)?
Hi Mark and welcome!
Send me a PM with your e-mail address and I can send you what we have for programming documentation and dlls.
Audiostrobe is a 2-channel format, but you can choose which colors will be used for each channel. In the Procyon editor, go to "Utilities/Set AudioStrobe colors and balance"
Re: Active-X control &/or dll for Procyon (also, general AS question)?
Thanks for the reply Andy .... will send you a message via your 'Contact Us' link.
Re: Active-X control &/or dll for Procyon (also, general AS question)?
Got it and replied.
Good luck!